Uzin HS 200 Tile Waterproofing Membrane, 27.5 lb Bag

Details

One-component - No latex admix needed
Fine textured raw materials - Smooth application
Tested and approved - Validated performance and peace of mind
No mesh required to meet ANSI A118.10 - Easier application & reduced potential of weak points
Variable water ratio - Control viscosity to preferred workability
Hybrid-set speed - Good working time, yet same-day tile installation
Light color - Easy to see reference lines

Over properly prepared concrete, masonry, cement mortar beds, and leveling coat
Over tile industry recommended backer boards
Over gypsum wallboard (interior)
Over industry-standard plywood (interior, dry conditions)
Over radiant heated substrates
Over UZIN brand surface preparation products where applicable
For use in showers, bathrooms, nursing homes, hotels, kitchens, laundry rooms, pools, spas, walkways, pool decks, balconies, building facades, fountains
For use in steam rooms or steam showers when used in conjunction with a vapor barrier (perm rating 0.1 or less ASTM E-96 Procedure A)
For contact with Schluter® Kerdi, Kerdi Drain, and other Schluter® components
For immersion and exterior applications, excellent freeze-thaw, aging, and fatigue resistance
To prevent in-plane floor cracks from transmitting through tile or stone

Technical Data

Packaging	27.5 lb (12.5 kg) paper bag
Storage	minimum 12 months
Layer thickness	40 mil (1 mm) double coat thickness build 20 mil (.5 mm)
Mixing ratio	3.7 – 4.8 quarts (3.5 – 4.5 liters) per 27.5 lb (12.5 kg) bag For partial bags mix at 3 parts powder to 1 part water
Color	Light grey
Coverage	80 – 90 sq. ft. (7.0 – 8.0 m²) @ two 20 mil coats (.5 mm)
VOC	0 g/L
Application temperature	40 – 95 °F (5 – 30 °C)
Drying time	Approx. 48 hrs.
Working time	approximately 1 hour*
Setting time / cure time	1st coat 2 hours* 2nd coat 5 hours*