Extend-O-Drain 4-3/8" Drain Height Extension Kit

Use to raise drain height by 1/4" or more.

Give your tile floor a finished look by raising low drain screens with these extensions. Each Extend-O-Drain Kit includes a 1/4" thick plastic drain height extension piece, three rubber washers, screws and brief instructions. Additional kits can be used for drain screens that need to be raised more than 1/4". Order kits by the size that corresponds to the hole center to center distance on the drain screen.

Instructions

1. Remove drain plate.
2. Place required number of washers (if any) then place drain extension over drain opening. (Be sure drain extension is installed after washers.)
3. Replace drain plate.
4. Insert appropriate screws and tighten.

NOTE: If screws appear too long you may have to use 1/8" or 3/32" drill bit to lengthen screw holes.