Better Bench BB-ADJR Adjustable Rectangular Shower Bench

Better-Bench is an easy to install bench-forming system that replaces the complex methods currently in use. This fully independent supporting unit can be mounted to most vertical surfaces quickly and efficiently, saving the installer valuable time. What once took days can now be done in about an hour!

This bench easily adjusts from 33-1/2" to 63" in length to adapt to your design needs and fit virtually any size shower. If the unit is expanded beyond 36" and/or an open ended installation is being considered, a BT-17S corbel support or Invisabolt support system is required. Supplied with hollow wall anchors and wood screws.

• Engineered 400 lb load capacity.
• Install before or after finish tile is applied to vertical surfaces.
• Self-supporting, one piece frame is easy to install with supplied fasteners, requiring no additional waterproofing or structural reinforcement.
• Use in wet or dry locations; mount over any U.B.C. approved substrate material.
• Takes only minutes to mount, place mortar mix (sand & cement), and tile as desired.
• Long lasting and corrosion resistant alloyed aluminum.
• Better-Bench is manufactured in the U.S.A.

Support Requirements:

• Mounting wall to wall up to 36": No additional support required
• Mounting wall to wall up to 63": One(1) BT-17S centered in span OR Two(2) Invisabolt supports
• Mounting on a back wall and one side wall up to 36": One(1) BT-17S within 6" of open-end OR 2 Invisabolt supports
• Mounting on a back wall and one side wall up to 63": Three(3) Invisabolt supports required
• Mounting with no side support up to 36": Two(2) Invisabolt supports required
• Mounting with no side support up to 48": Three(3) Invisabolt supports required
• Mounting with no side support up to 63" max span: Four(4) Invisabolt supports required